DS1305 Datasheet Download

Part No.:
DS1305
Download:
Download Datasheet
Description:
[Serial Alarm Real-Time Clock]
File Size:
307 K
Page:
22 Pages
Logo:
Manufacturer:
MAXIM [ MAXIM INTEGRATED PRODUCTS ]
PCB Prototype
 DS1305 Datasheet Page:4DS1305 Datasheet Page:5DS1305 Datasheet Page:6DS1305 Datasheet Page:7DS1305 Datasheet Page:9DS1305 Datasheet Page:10DS1305 Datasheet Page:11DS1305 Datasheet Page:12 
DS1305
AIE1 (Alarm Interrupt Enable 1)
– When set to a logic 1, this bit permits the interrupt 1 request flag
(IRQF1) bit in the status register to assert
INT1
(when INTCN = 1) or to assert
INT0
(when INTCN = 0).
When the AIE1 bit is set to logic 0, the IRQF1 bit does not initiate an interrupt signal.
STATUS REGISTER (READ 10h)
BIT7
0
BIT6
0
BIT5
0
BIT4
0
BIT3
0
BIT2
0
BIT1
IRQF1
BIT0
IRQF0
IRQF0 (Interrupt 0 Request Flag)
– A logic 1 in the interrupt request flag bit indicates that the current
time has matched the Alarm 0 registers. If the AIE0 bit is also a logic 1, the
INT0
pin goes low. IRQF0 is
cleared when the address pointer goes to any of the Alarm 0 registers during a read or write.
IRQF1 (Interrupt 1 Request Flag)
– A logic 1 in the interrupt request flag bit indicates that the current
time has matched the Alarm 1 registers. This flag can be used to generate an interrupt on either
INT0
or
INT1
depending on the status of the INTCN bit in the control register. If the INTCN bit is set to a logic 1
and IRQF1 is at a logic 1 (and AIE1 bit is also a logic 1), the
INT1
pin goes low. If the INTCN bit is set
to a logic 0 and IRQF1 is at a logic 1 (and AIE1 bit is also a logic 1), the
INT0
pin goes low. IRQF1 is
cleared when the address pointer goes to any of the Alarm 1 registers during a read or write.
TRICKLE CHARGE REGISTER (READ 11H, WRITE 91H)
This register controls the trickle charge characteristics of the DS1305. The simplified schematic of Figure
3 shows the basic components of the trickle charger. The trickle-charge select (TCS) bits (bits 4–7)
control the selection of the trickle charger. To prevent accidental enabling, only a pattern of 1010 enables
the trickle charger. All other patterns disable the trickle charger. On the initial application of power, the
DS1305 powers up with the trickle charger disabled. The diode select (DS) bits (bits 2–3) select whether
one diode or two diodes are connected between V
CC1
and V
CC2
. The resistor select (RS) bits select the
resistor that is connected between V
CC1
and V
CC2
. The resistor and diodes are selected by the RS and DS
bits, as shown in Table 3.
Figure 3. PROGRAMMABLE TRICKLE CHARGER
8 of 22