CY7C4265-15AC Datasheet Download

Part No.:
CY7C4265-15AC
Download:
Download Datasheet
Description:
[8K/16K x 18 Deep Sync FIFOs]
File Size:
625 K
Page:
23 Pages
Logo:
Manufacturer:
CYPRESS [ CYPRESS SEMICONDUCTOR ]
PCB Prototype
 CY7C4265-15AC Datasheet Page:2CY7C4265-15AC Datasheet Page:3CY7C4265-15AC Datasheet Page:4CY7C4265-15AC Datasheet Page:5CY7C4265-15AC Datasheet Page:6CY7C4265-15AC Datasheet Page:7CY7C4265-15AC Datasheet Page:8CY7C4265-15AC Datasheet Page:9 
CY7C4255, CY7C4265, CY7C4265A
8K/16K x 18 Deep Sync FIFOs
Features
Functional Description
The CY7C4255/65/65A are high speed, low power, first-in
first-out (FIFO) memories with clocked read and write interfaces.
All are 18 bits wide and are pin/functionally compatible to the
CY7C42X5 Synchronous FIFO family. The CY7C4255/65/65A
can be cascaded to increase FIFO depth. Programmable
features include Almost Full/Almost Empty flags. These FIFOs
provide solutions for a wide variety of data buffering needs, including
high speed data acquisition, multiprocessor interfaces, and communi-
cations buffering.
These FIFOs have 18-bit input and output ports that are
controlled by separate clock and enable signals. The input port
is controlled by a free running Clock (WCLK) and a Write Enable
pin (WEN). When WEN is asserted, data is written into the FIFO on the
rising edge of the WCLK signal. While WEN is held active, data is contin-
ually written into the FIFO on each cycle. The output port is controlled in
a similar manner by a free-running Read Clock (RCLK) and a Read
Enable pin (REN). In addition, the CY7C4255/65/65A have an Output
Enable pin (OE). The read and write clocks may be tied together for
single-clock operation or the two clocks may be run independently for
asynchronous read/write applications. Clock frequencies up to
100 MHz are achievable.
Retransmit and Synchronous Almost Full/Almost Empty flag
features are available on these devices. Depth expansion is
possible using the Cascade Input (WXI, RXI), Cascade Output
(WXO, RXO), and First Load (FL) pins. The WXO and RXO pins are
connected to the WXI and RXI pins of the next device, and the WXO
and RXO pins of the last device should be connected to the WXI and
RXI pins of the first device. The FL pin of the first device is tied to V
SS
and the FL pin of all the remaining devices should be tied to V
CC
.
D
0–17
INPUT
REGISTER
High Speed, Low Power, First-In First-Out (FIFO) Memories
8K x 18 (CY7C4255)
16K x 18 (CY7C4265/4265A)
0.5 Micron CMOS for Optimum Speed and Power
High Speed 100 MHz Operation (10 ns read/write cycle times)
Low Power — I
CC
= 45 mA
Fully Asynchronous and Simultaneous Read and Write
Operation
Empty, Full, Half Full, and Programmable Almost Empty and
Almost Full Status Flags
TTL compatible
Retransmit Function
Output Enable (OE) Pins
Independent Read and Write Enable Pins
Center Power and Ground Pins for Reduced Noise
Supports Free-running 50 percent Duty Cycle Clock Inputs
Width and Depth Expansion Capability
64-pin TQFP and 64-pin STQFP
Pin-compatible Density Upgrade to CY7C42X5 Family
Pin-compatible Density Upgrade to IDT72205/15/25/35/45
Pb-free Packages Available
Logic Block Diagram
WCLK
WEN
WRITE
CONTROL
FLAG
PROGRAM
REGISTER
RAM
ARRAY
8K x 18
16K x 18
WRITE
POINTER
FLAG
LOGIC
FF
EF
PAE
PAF
SMODE
READ
POINTER
RS
RESET
LOGIC
FL/RT
WXI
WXO/HF
RXI
RXO
EXPANSION
LOGIC
THREE–STATE
OUTPUT REGISTER
Q
0–17
OE
READ
CONTROL
RCLK
REN
Note
1. CY7C4265 and CY7C4265A are functionally identical
Cypress Semiconductor Corporation
Document #: 38-06004 Rev. *E
198 Champion Court
San Jose
,
CA 95134-1709
408-943-2600
Revised June 03, 2009